Barco Projector 26-0313000-00 Benutzerhandbuch

ImagePRO Aux Configuration

ImagePRO units can be connected to the Encore Controller via Ethernet for use as Aux 
destinations.  In this manner, AUX outputs from up to three routers are connected to the 
ImagePRO — so that any available source used in the Encore system can be displayed on 
a given monitor.  

The diagram below shows a ImagePRO Aux configuration that uses one analog router, one 
DVI router and one SDI router.  

Figure D-6.  ImagePRO Aux connections 

„

Use the following steps to properly prepare an ImagePRO system for setup as an Aux 
destination:

Ensure that you are running software Version 2.30 (or above) on the ImagePRO.  
If not, download software in the normal manner from the FTP site 
(

) or the web site (

On each router (1 x Analog, 1 x SDI, 1 x DVI), ensure that an unused router output 
is physically connected to an ImagePRO input.  Make a note of these connection 
patches, as they will need to be entered during the setup procedure.

Before you connect the ImagePRO to the Encore Controller, set up the 
ImagePRO’s output resolution at the unit itself.  Ensure that you match the 
resolution of the monitor connected to the system.  

On ImagePRO’s Effects Menu, set up the transition parameters that the unit will 
use when AUTO TRANS is pushed on the Encore Controller. 

Complete the setup procedure by setting up the Aux destination(s) on the Encore 
Controller.  In Chapter 6, refer to the “

page 281 for instructions.

MatrixPRO SDI Router

MatrixPRO Analog Router

Encore Controller (SC or LC)

ImagePRO

Ethernet Switch

Monitor

Router

Outputs

Inputs

SDI 

Inputs

Analog 

Inputs

MatrixPRO DVI Router

DVI 

Inputs