Barco Projector 26-0313000-00 Benutzerhandbuch
398
Encore Presentation System • User’s Guide • Rev 04
aK==tçêâáåÖ=táíÜ=aÉëíáå~íáçåë
PresentationPRO-II Aux Configuration
mêÉëÉåí~íáçåmolJff=^ìñ=`çåÑáÖìê~íáçå
PresentationPRO-II units can be connected to the Encore Controller via Ethernet for use as
Aux destinations. In this manner, AUX outputs from up to two routers are connected to the
PresentationPRO-II — so that any available source used in the Encore system can be
displayed on a given monitor.
Aux destinations. In this manner, AUX outputs from up to two routers are connected to the
PresentationPRO-II — so that any available source used in the Encore system can be
displayed on a given monitor.
The diagram below shows a PresentationPRO-II Aux configuration that uses one analog
router and one SDI router.
router and one SDI router.
Figure D-5. PresentationPRO-II Aux connections
Use the following steps to properly prepare a PresentationPRO-II system for setup as
an Aux destination:
an Aux destination:
1.
Ensure that you are running software Version 1.12 (or above) on the
PresentationPRO-II. If not, download software in the normal manner from the
FTP site (
PresentationPRO-II. If not, download software in the normal manner from the
FTP site (
2.
On each router (1 x Analog, 1 x SDI), ensure that an unused router output is
physically connected to a PresentationPRO-II input. Make a note of these
connection patches, as they will need to be entered during the setup procedure.
physically connected to a PresentationPRO-II input. Make a note of these
connection patches, as they will need to be entered during the setup procedure.
3.
Before you connect the PresentationPRO-II to the Encore Controller, set up the
PresentationPRO-II’s output resolution at the unit itself. Ensure that you match
the resolution of the monitor connected to the system.
PresentationPRO-II’s output resolution at the unit itself. Ensure that you match
the resolution of the monitor connected to the system.
4.
On PresentationPRO-II’s Effects Menu, set up the transition parameters that the
unit will use when AUTO TRANS is pushed on the Encore Controller.
unit will use when AUTO TRANS is pushed on the Encore Controller.
5.
(Optional) If a BG (background) or DSK (Downstream Key) needs to be on
Program at all times, set up this input on the PresentationPRO-II, and transition it
to Program — prior to placing the PresentationPRO-II into remote control mode.
Program at all times, set up this input on the PresentationPRO-II, and transition it
to Program — prior to placing the PresentationPRO-II into remote control mode.
6.
Complete the setup procedure by setting up the Aux destination(s) on the Encore
Controller. In Chapter 6, refer to the “
Controller. In Chapter 6, refer to the “
page 281 for instructions.
MatrixPRO SDI Router
MatrixPRO Analog Router
Encore Controller (SC or LC)
PresentationPRO-II
Ethernet Switch
Monitor
Router
Outputs
Inputs
SDI
Inputs
Analog
Inputs