BLACKHAWK! Power Supply Blackhawk Series Broadband Power Supplies Benutzerhandbuch

5. INSTALLATION NOTE:  Do not install batteries until verifying that the cabinet 

 

6. 

Install the power supply and batteries in the cabinet as outlined in this manual.

 

 

 

Section 4:   Front Panel Controls, Connections and Indicators 

 
The front panel of the power supply contains various connectors, indicators and all operator 
controls.   These items are described as follows. 
 

Controls 
 
Circuit Breakers:  Input and output circuit breakers are described as follows: 
 
a)  Output Circuit Breaker:  This 20-amp circuit breaker, located at the left side of the 

front panel, protects the power supply in case a fault condition occurs on the output 
circuit.  This circuit breaker is a push-to-reset device. 

 
b)  Battery Circuit Breaker:  80 amp circuit breaker protects battery circuit and input 

wiring.  This circuit breaker is also used as a DC switch to apply and remove battery 
power to the power supply. 

 
 

Switches:  One pushbutton switch controls functions within the power supply: 
 
TEST Switch:  This switch, located below the indicator LEDs on the front panel of the 
inverter module, initiates and cancels local battery test. 
 
Connections: 

 

Output Connectors: 
 
The Blackhawk Series power supplies contain one power output connector, located in 
the lower left corner of the front panel.  The mating Anderson mini-power pole 
connector provides the means for connecting output power to the appropriate network 
power connector in the cabinet.  The black connector is hot; the white connector is 
ground return for the output. 
 
BATTERY: Anderson-type connector: used for connecting the external battery to the 
power supply. 
 
BATTERY TEMP SENSOR:  Mini Mate-N-Lok: connects the external temperature 
probe for temperature compensated battery charging. 
 

 

14