Bil-Jax Wheelchair XLB-4232 DC Benutzerhandbuch
XLB-4232 DC
1-6
1-4 MAINTENANCE SAFETY
Ensure the following safety precautions are observed whenever maintenance is performed
on the XLB-4232 DC Boom Lift.
on the XLB-4232 DC Boom Lift.
General Maintenance
•
ALWAYS perform maintenance procedures according to manufacturer's
requirements. NEVER short change maintenance procedures.
•
ALWAYS check hydraulic system. Make sure all lines, connectors, and fittings
are tight and in good condition.
•
ALWAYS turn the MASTER POWER switch OFF before connecting or
disconnecting wiring to or from valve solenoids or other load devices.
•
ALWAYS disconnect power to the hydraulic pump drive motor before making
electrical checks of the hydraulic valves.
•
ALWAYS keep all mechanisms properly adjusted and lubricated according to
maintenance schedule and manufacturer’s specifications.
•
ALWAYS perform a function check of operating controls before each use and
after repairs have been made.
•
ALWAYS locate and protect against possible pinch points prior to performing
maintenance and repairs.
•
ALWAYS use factory-approved parts to repair or maintain this equipment. If
this equipment is rebuilt, retesting is required in accordance with factory
instructions.
instructions.
•
NEVER allow water or foreign particles into the DC electric motor housing.
Ingestion of water or foreign particles may cause serious damage to the motor. If
the motor gets wet, oven dry the motor to remove all moisture before operating;
consult motor manufacturer for drying instructions.
the motor gets wet, oven dry the motor to remove all moisture before operating;
consult motor manufacturer for drying instructions.
•
NEVER test or operate the hydraulic components when another person is near
the equipment.
•
NEVER add unauthorized fluids to the hydraulic system or battery. Check
original manufacturer specifications.
•
NEVER exceed the manufacturer's recommended relief valve settings.
•
NEVER touch or allow metal tools to contact static discharge sensitive
electronic components. ALWAYS use static discharge prevention mats and
grounding devices when handling electronic components.
grounding devices when handling electronic components.
•
NEVER tamper with cylinder counter balance valves. Contact the Bil-Jax
Service Department at 419.445.9675 if the cylinder counter balance valves need
adjusting.
adjusting.
•
NEVER attempt repairs you do not understand. Consult manufacturer if you
have any questions regarding proper maintenance, specifications, or repair.