Bil-Jax Wheelchair XLB-4232 DC Benutzerhandbuch

Seite von 116
 
1 — SAFETY 
 
1-3 
1-2  BEFORE  OPERATION 
Ensure the following general safety precautions are followed before operating the 
XLB-4232 DC Boom Lift. 
  ALWAYS survey the usage area for potential hazards such as untamped earth 
fills, unlevel surfaces, overhead obstructions, and electrically charged conductors 
or wires. Be aware of any potential hazards and always consider what could 
happen. Watch for moving vehicles in the operating area. 
  ALWAYS read, understand, and follow the procedures in this manual before 
attempting to operate equipment. 
  ALWAYS inspect the equipment for damaged or worn parts. Check for cracked 
welds, hydraulic leaks, damaged wiring, loose wire connectors, damaged 
outriggers, low tire pressure, uneven tire wear, or tire damage. Also check for 
any improper operation. NEVER operate equipment if damaged in any way. 
Improperly operating equipment must be repaired before using. 
  ALWAYS wear proper clothing for the job. Wear protective equipment as 
required by federal, state, or local regulations. The operator MUST wear a safety 
harness and lanyard. 
  ALWAYS locate, read, and follow all directions and warnings displayed on the 
equipment. 
  ALWAYS inspect the equipment for “DO NOT USE” tags. NEVER use 
equipment tagged in this way until all repairs are made and all “DO NOT USE” 
tags are removed by authorized maintenance personnel. 
  ALWAYS make sure the basket and outrigger shoes are free of mud, grease, or 
other slippery material to reduce the possibility of slipping. 
  NEVER allow improperly trained personnel to operate this equipment. Only 
trained and authorized personnel shall be allowed to operate this equipment. 
  NEVER operate this equipment if you are under the influence of alcohol or 
drugs, or if you feel ill, dizzy, or unsteady in any way. Operators must be 
physically fit, thoroughly trained, and not easily excitable. 
  NEVER modify, alter, or change the equipment in any way that would affect its 
original design or operation in any way. 
  NEVER operate this equipment in ways for which it is not intended.