BIC VOLVO C30 T5 Benutzerhandbuch
Volvo C30 T5 Intercooler System
/ Installation Manual
6
Bell Intercoolers, inc. © 2008 All rights reserved. C30-IMv1
4.6 Recheck All Fasteners, Hose Clamps and Connections
Before proceeding, recheck all hose clamps for proper installation and clearance. Also recheck intercooler position (as per step
4.3) and all mounting fasteners. Recheck IAT sensor harness to be sure it is properly connected.
Start Engine and Check Connections
Before reinstalling the front fascia body work it is recommended that you remove the car from the jack stands or lift in order to
check engine operation and make sure all components are functioning properly. The car will be started, but not be driven at this
time, to determine that all components have been connected properly. Do not start car while on jack stands.
• Remove car from jack stands or lift.
• Reconnect battery.
• Start engine and allow engine to warm to operating temperature.
• Engine should idle and rev normally. If it does not, shut off engine and check for loose intercooler hose connections and dis-
• Remove car from jack stands or lift.
• Reconnect battery.
• Start engine and allow engine to warm to operating temperature.
• Engine should idle and rev normally. If it does not, shut off engine and check for loose intercooler hose connections and dis-
connected IAT sensor wiring harness. Restart engine and check for normal idle and revs.
• Shut off engine and disconnect battery.
• Place car back on jack stands or lift to complete installation of front fascia bodywork.
• Place car back on jack stands or lift to complete installation of front fascia bodywork.
5.0
Figure 4.5
Figure 4.6
Left-Side Mounting Point
Intercooler
Tube
Intercooler
Hose
Hose
Clamp
Retaining
Bead
1”
Mark
Line
Figure 4.7
Hose and Clamp Placement Diagram
Intercooler
Mounting
Point
Intercooler
To Radiator
Gap
Figure 4.4
Right-Side Mounting Point
Intercooler
Mounting
Point