Woodstock SHOP FOX W1668 Benutzerhandbuch

-

11

-

Figure 12. Hold rack in position while installing.

Figure 13. Inside bevel in the correct position.

Figure 14. Lock shoe in place and secured.

Examine the rack and note that the gear
teeth extend further on one end than the
other. Insert the rack into the table support
bracket and align with pocket. The end of
the rack where the gear teeth are closest to
the end should be positioned down when
the support bracket is oriented as in Figure
12. The gear teeth on the rack must also
face out.

Slide the table support bracket onto the
column while holding the rack in place.
Allow the bracket to go down until the bot-
tom of the rack contacts the shoulder on the
column support. Secure the table with the
lock handle.

Slide the column ring onto the column with the
inside bevel in the down position. Figure 13.
Adjust the ring until the tip of the rack fits
inside the bevel. Tighten the setscrew on the
ring. Do not over tighten.

Use caution when tightening set screw. Over tight-

ening will split column ring.

Thread the 10mm lock handle into the table
bracket.

Insert the lock shoe into the table support
bracket and secure with setscrews on either
side. Refer to step 3 under heading Table
Support if needed.

Align the shaft under the table with the hole
on the end of the table support bracket.
Figure 14.