Woodstock SHOP FOX W1668 Benutzerhandbuch
-
12
-
HeadStock
1.
The bottom of the headstock has a pocket
for inserting the column. Position the pock-
et over the column, as in Figure 15. Allow
the headstock to slide down until it stops
(approximately 3
for inserting the column. Position the pock-
et over the column, as in Figure 15. Allow
the headstock to slide down until it stops
(approximately 3
1
⁄
2
").
2.
Align the headstock directly over the foot of
the base by using a plumb bob. Lay a mea-
suring tape or ruler across the drill press
base and find its center. Suspend the plumb
line from the center of the headstock label
as in Figure 16 and lower the bob until it is
near the tape/ruler. Adjust headstock from
side to side until the tip is equidistant from
the left and right sides.
the base by using a plumb bob. Lay a mea-
suring tape or ruler across the drill press
base and find its center. Suspend the plumb
line from the center of the headstock label
as in Figure 16 and lower the bob until it is
near the tape/ruler. Adjust headstock from
side to side until the tip is equidistant from
the left and right sides.
3.
Tighten the two setscrews in Figure 17 to
secure the headstock to the column.
secure the headstock to the column.
The headstock repre-
sents a heavy load. Seek
assistance before begin-
ning this step.
sents a heavy load. Seek
assistance before begin-
ning this step.
Figure 15. Align pocket in headstock with column.
Figure 16. Align headstock with base.
Figure 17. Tighten setscrews to secure headstock.