Woodstock SHOP FOX W1668 Benutzerhandbuch
Always wear safety glass-
es when operating drill
press. Failure to comply
may result in serious per-
sonal injury.
-
18
-
OPERATIONS
Once assembly is complete and adjustments are
done to your satisfaction, you are ready to test
run the machine.
done to your satisfaction, you are ready to test
run the machine.
Make sure the starting switch is off. The paddle
is down when off. Make sure all the fasteners
and lock handles are tight. Plug in the power
cord. Pull the START paddle. Make sure that your
finger is poised over the paddle,as in Figure 30,
just in case there is a problem. The drill press
should run smoothly, with little or no vibration or
rubbing noises. Strange or unnatural noises
require you to stop the machine, investigate and
correct before continuing. If source of unusual
noise or vibration is not readily apparent, con-
tact our service department for help at 360-734-
3482 or: tech-support@woodstockint.com.
is down when off. Make sure all the fasteners
and lock handles are tight. Plug in the power
cord. Pull the START paddle. Make sure that your
finger is poised over the paddle,as in Figure 30,
just in case there is a problem. The drill press
should run smoothly, with little or no vibration or
rubbing noises. Strange or unnatural noises
require you to stop the machine, investigate and
correct before continuing. If source of unusual
noise or vibration is not readily apparent, con-
tact our service department for help at 360-734-
3482 or: tech-support@woodstockint.com.
Test Run
DO NOT attempt to inves-
tigate or adjust the
machine while it is run-
ning. Wait until the
machine is turned off,
unplugged and all work-
ing parts have come to a
stop before proceeding!
tigate or adjust the
machine while it is run-
ning. Wait until the
machine is turned off,
unplugged and all work-
ing parts have come to a
stop before proceeding!
Figure 30. Hand poised over stop paddle.