Woodstock SHOP FOX W1668 Benutzerhandbuch
Installing the sanding drum spindle is identical to installing a drill bit. However, it is important to install
the paper and drum before installing the spindle into the drill chuck. See your local retailer for drums
and paper.
the paper and drum before installing the spindle into the drill chuck. See your local retailer for drums
and paper.
-
19
-
Care must be taken to secure the bit firmly in
the drill chuck. When changing bits, proceed as
follows:
the drill chuck. When changing bits, proceed as
follows:
1.
Disconnect the machine from the power
source.
source.
2.
Open the chuck wide enough to accept a
drill bit.
drill bit.
3.
Install the bit so the chuck jaws will grab as
much of the bit shank as it can. Figure 31.
Do not allow the chuck to grab the fluted
body of the drill bit. Make sure small drill
bits do not get trapped between the edges
of two jaws.
much of the bit shank as it can. Figure 31.
Do not allow the chuck to grab the fluted
body of the drill bit. Make sure small drill
bits do not get trapped between the edges
of two jaws.
Drill Changes
Figure 32. Chuck key engaged.
Figure 31. Installing bit.
4.
Tighten the chuck with the chuck key using
any of the three key end locations. Figure
32.
any of the three key end locations. Figure
32.
5.
Remove the chuck key and reconnect to the
power source.
power source.
6.
Reverse steps to remove the drill bit.
Never drill or sand with-
out the table for support
and workpiece properly
secured. Serious per-
sonal injury may occur.
out the table for support
and workpiece properly
secured. Serious per-
sonal injury may occur.