Whirlpool WFG710H0AS Installationsanweisungen

Seite von 40
12
3. If the oven bake flame needs to be adjusted, locate the air 
shutter near the center rear of the range. Loosen the locking 
screw and rotate the air shutter until the proper flame 
appears. Tighten locking screw.
4. Push CANCEL/OFF when finished. 
5. Reinstall flame spreader and oven bake burner cover.
Check Operation of Oven Broil Burner
1. Close the oven door.
2. Press the BROIL pad.
3. Press the START pad.
The oven burner should light within 8 seconds. Under certain 
conditions, it may take the burner up to 50 to 60 seconds to light. 
Refer to the Use and Care Guide or User Instructions for proper 
operation of the oven controls.
Adjust Oven Broil Burner Flame (if needed)
Look through oven window to check broil burner for proper 
flame. This flame should have a ½" (1.3 cm) long inner cone of 
bluish-green, with an outer mantle of dark blue, and should be 
clean and soft in character. No yellow tips, blowing or lifting of 
flame should be present.
If flame needs to be adjusted:
1. Loosen the lock screw on the air shutter located at the rear of 
the broil burner.
2. Adjust the air shutter as needed. 
3. Tighten lock screw.
4. Press CANCEL/OFF when finished.
Warming Drawer or Premium Storage 
Drawer
(on some models)
Remove all items from inside the warming drawer or premium 
storage drawer, and allow the range to cool completely before 
attempting to remove the drawer.
To Remove:
1. Open the warming drawer or premium storage drawer to its 
fully open position.
2. Using a flat-blade screwdriver, gently loosen the warming 
drawer or premium storage drawer from the glide alignment 
notch and lift up the drawer alignment tab from the glide.
3. Repeat Step 2 on the other side. The warming drawer or 
premium storage drawer is no longer attached to the drawer 
glides. Using both hands, pick up the warming drawer or 
premium storage drawer to complete the removal.
To Replace:
1. Align the forward drawer notches with the notches in the 
drawer glides on both sides. Place the rear alignment tabs 
into the drawer glides on both sides.
2. Push the warming drawer or premium storage drawer in all 
the way.
3. Gently open and close the warming drawer or premium 
storage drawer to ensure it is seated properly on the glides 
on both sides.
A. Locking screw
B. Air shutter
A. Lock screw
B. Air shutter
A
B
A
B
A. Flat-blade screwdriver
B. Drawer alignment tab
C. Drawer glide notch
A. Drawer alignment tab
B. Drawer glide notch
A
B
C
A
B