Whirlpool WFG710H0AS Installationsanweisungen

The storage drawer can be removed. Before removing, make sure 
drawer is cool and empty.

1. Pull the storage drawer straight back to the drawer stop.

2. Lift up the front of the drawer and pull the drawer out.

1. Lift up the front of the drawer and place the rear of the drawer 

inside the range so that the drawer stop notch is behind the 
drawer glide.

2. Lower the drawer so that the edge of the slide rail drops into 

the slot in the drawer glide.

3. Slowly push the drawer into the range.

NOTE: When properly installed, the rear slides on the bottom 
of the drawer will engage the base rails and the drawer will 
not tip when items are placed in the drawer.

For normal range use, it is not suggested to remove the oven 
door. However, if removal is necessary, make sure the oven is off 
and cool. Then, follow these instructions. The oven door is heavy.

1. Open oven door all the way.

2. Pinch the hinge latch between two fingers and pull forward. 

Repeat on other side of oven door.

3. Close the oven door as far as it will shut.

4. Lift the oven door while holding both sides.

Continue to push the oven door closed and pull it away from 
the oven door frame.

1. Insert both hanger arms into the door.

2. Open the oven door.

You should hear a “click” as the door is set into place.

3. Move the hinge levers back to the locked position. Check 

that the door is free to open and close. If it is not, repeat the 
removal and installation procedures.

1. Check that all parts are now installed. If there is an extra part, 

go back through the steps to see which step was skipped.

2. Check that you have all of your tools.

3. Dispose of/recycle all packaging materials.

4. Check that the range is level. See the “Level Range” section.

5. Use a mild solution of liquid household cleaner and warm 

water to remove waxy residue caused by shipping material. 
Dry thoroughly with a soft cloth. For more information, see 
the “Range Care” section of the Use and Care Guide or User 
Instructions.

6. Read the Use and Care Guide or User Instructions.

7. Turn on surface burners and oven. See the Use and Care 

Guide or User Instructions for specific instruction on range 
operation. 

■

Household fuse is intact and tight, or circuit breaker has not 
tripped.

■

Range is plugged into a grounded 3 prong outlet.

■

Electrical supply is connected.

■

See “Troubleshooting” in the Use and Care Guide or User 
Instructions.

8. When the range has been on for 5 minutes, check for heat. If 

the range is cold, turn off the range and check that the gas 
supply line shutoff valve is open.

■

If the gas supply line shutoff valve is closed, open it, then 
repeat the 5-minute test as outlined above.

■

If the gas supply line shutoff valve is open, press the 
CANCEL button on the oven control panel and contact a 
qualified technician.

Please reference the “Assistance or Service” section of the Use 
and Care Guide or the cover of the User Instructions, or contact 
the dealer from whom you purchased your range.

A

A