Woods Equipment 8100 Benutzerhandbuch
10
PN-51210 (Rev. 7/98)
6
4
7
2
1
5
PTO Model
Controls
Figure 5
1. Three pt. Hitch Connection: Mounts chipper to tractor 3 pt. hitch.
Connect direct for category 1.
2. PTO Shaft: Connects chipper to tractor PTO shaft. Avoid driveline
angles over 20 degrees on PTO shaft when unit is in use.
3. Drive Belt Shield: Never remove shield while machine is running.
4. Chipper Chute: Feeds materials to the chipper blades for chipping.
5. Leg Stands: Never move machine unless legs are in UP position and
4. Chipper Chute: Feeds materials to the chipper blades for chipping.
5. Leg Stands: Never move machine unless legs are in UP position and
clear the ground.
6. Rotor Access Cover: Tilts up to remove chipper blades and to service
rotor assembly.
7. Discharge Tube: Chipped materials will exit through this tube. Tube is
adjustable 360 degrees.
8. Adjustable Chipping Anvil: Adjusts to vary the size of chips.
9. Rotor Shaft Bearing Cover: Rotor shaft has lock assembly to lock rotor
9. Rotor Shaft Bearing Cover: Rotor shaft has lock assembly to lock rotor
in place while moving.
C
O N T R O L S
8
3
9
Controls
(see figure 5)