Woods Equipment 8100 Benutzerhandbuch

PN-51210 (Rev. 7/98)

P E R A T I O N

Telescoping Type

20 to 28 inches will leave

at least 4 inches overlap

Figure 6

CAUTION: Wear safety glasses at all times when operating the

machine. Do not wear loose fitting clothing. The operator should always

wear heavy boots, gloves, pants, and shirt. Use common sense and practice

safety to protect yourself from branches, sharp objects, and other harmful

objects.

NOTE: The heavy rotor continues to turn for some time after the tractor

has been shut off. The rotor is stopped when no noise or machine vibration

is present. Inserting a branch into the chipper chute to contact the blades

slows the rotor and shortens stopping time.

NOTE: Minimum and maximum telescoping on the PTO shaft is 20-28

inches. This will leave 4 inches overlap at maximum telescoping distance

(see figure 6).

1. Place tractor transmission in park or neutral and set parking brake.

Connect 3 pt. mounts between the chipper and tractor. Secure connec-

tions with snap pins. Adjust 3 pt. top link so chipper sits level.

2. Connect PTO shaft to tractor. Make sure you are using the correct RPM

machine. Do not operate machine at speeds different than specified on

shield.

3. Do not inspect or work on PTO drive area without first disengaging PTO

and shutting off tractor engine.

4. Start tractor engine and engage PTO drive clutch (see tractor owner's

manual). Increase engine speed to rated PTO RPM position.

WARNING: This

chipper is designed
to be used with
tractor PTO's rated
at 20 to 60
horsepower. Using
this chipper with
PTO's above 60
horsepower may
cause belt and
machine damage in
overload conditions.

Operation

Starting