Whirlpool SF3020EK Benutzerhandbuch

3. Tilt top of door toward range. Insert bottom door hinge notch 

down onto front frame edge.

4. Open the door completely and remove the hinge pins. Save 

hinge pins for future use.

5. Close the door slowly to assure door side panel clearance 

and proper hinge engagement.

■

Is the power outlet properly wired and polarized?
Try another outlet to check for proper wiring and polarity.

■

Is the power supply cord unplugged?
Plug into a properly grounded 3 prong outlet.

■

Has a household fuse been blown or has the circuit 
breaker been tripped?
Replace the fuse or reset the circuit.

■

Is the main or regulator gas shutoff valve in the off 
position?
See Installation Instructions.

■

Is the range properly connected to the gas supply?
Contact a trained repair specialist or see Installation 
Instructions.

■

Is this the first time the surface burners have been used?    
Turn on any one of the surface burner knobs to release air 
from the gas lines.

■

Is the control knob set correctly?
Push in knob before turning to a setting.

■

Are the burner ports clogged?
On sealed burner models, see “Sealed Surface Burners” 
section.
On open burner models, see “Surface Burners” section.

■

Is the pilot light out?
Light the surface burner pilots. (See “Pilot Lights” section.)

■

Are the burner ports clogged? 
On sealed burner models, see “Sealed Surface Burners” 
section.
On open burner models, see “Surface Burners” section.

■

On models with caps, are the burner caps positioned 
properly?
See “Sealed Surface Burners” section.

■

Is the burner damaged?
On models with caps, look for warped cap. Place cap, flat 
side-down, on a flat surface. If cap wobbles noticably, it is 
warped. Place cap on different burner for further check of 
warping. Replace warped cap. Contact a trained repair 
specialist if the condition does not improve.

■

■

■

■

Is the air/gas mixture correct?
Contact a designated service technician to check the air/gas 
mixture, or see the Installation Instructions.

■

Is propane gas being used?
The appliance may have been converted improperly.    
Contact a trained repair specialist.

■

Is the burner wet?
Let it dry.

■

Is the range level?
Level the range. (See the Installation Instructions.)

■

Is the proper cookware being used?
Use cookware with a flat bottom. (See “Cookware” section.)

■

Is the cookware the proper size?
Use cookware about the same size as the surface cooking 
area, element or surface burner. Cookware should not extend 
more than 1 in. (2.5 cm) outside the cooking area.

■

Is the power outlet properly wired and polarized?
Try another outlet to check for proper wiring and polarity.

■

Is this the first time the oven has been used?
Turn any one of the surface burner knobs on to release air 
from the gas lines.

■

Is the oven temperature control knob set correctly?
See “Cooktop/Oven Temperature Controls” section.

■

Is the main or regulator gas shutoff in the off position?
Contact a designated service technician or see the 
Installation Instructions.

■

This is normal and occurs when the oven burner cycles on 
and off to hold the set oven temperature.

■

Is propane gas being used?
The appliance may have been converted improperly. Contact 
a trained repair specialist.

■

Is the air/gas mixture correct?
Contact a designated service technician to check the air/gas 
mixture or see the Installation Instructions.