Whirlpool W10136155B Benutzerhandbuch

Remove tape and glue from your ice maker before using.

■

To remove any remaining tape or glue, rub the area briskly 
with your thumb. Tape or glue residue can also be easily 
removed by rubbing a small amount of liquid dish soap over 
the adhesive with your fingers. Wipe with warm water 
and dry.

■

Do not use sharp instruments, rubbing alcohol, flammable 
fluids, or abrasive cleaners to remove tape or glue. These 
products can damage the surface of your ice maker. 

After you remove all of the packaging materials, clean the inside 
of your ice maker before using it. See the cleaning instructions in 
the “Ice Maker Care” section.

■

To ensure proper ventilation for your ice maker, the front side 
must be completely unobstructed. The unit may be closed-in 
on the top and 3 sides, but the installation should allow the 
ice maker to be pulled forward for servicing if necessary.

■

Installation of the ice maker requires a cold water supply inlet 
of 

¹⁄₄" (6.35 mm) OD soft copper tubing with a shutoff valve 

and either a gravity-drain system or condensate pump to 
carry the water to an existing drain.

■

Choose a well ventilated area with temperatures above 55°F 
(13°C) and below 100°F (38°C). Best results are obtained 
between 70°F (21°C) and 90°F (32°C). 

■

This unit must be installed in an area protected from the 
elements, such as wind, rain, water spray, or drip.

■

When installing the ice maker under a counter, follow the 
recommended opening dimensions shown. Place electrical 
and plumbing fixtures in the recommended location as 
shown.

NOTE: Do not kink or pinch the power supply cord between 
the ice maker and cabinet.

■

You should choose a location where the floor is even. It is 
important for the ice maker to be level in order to work 
properly. If needed, you can adjust the height of the ice maker 
by changing the height of the leveling legs. See “Leveling.” 

: 

■

Plug into a grounded 3 prong outlet.

■

Do not remove ground prong.

■

Do not use an adapter.

■

Do not use an extension cord.

■

Disconnect power before cleaning.

■

Disconnect power before servicing.

■

Replace all parts and panels before operating.

■

Use two or more people to move and install ice maker.

    

B

A