Teleflex Marine 311482-002 Benutzerhandbuch

Page 4 of 4 Pages

8.

Attach the other end of the second wire to
the ground point, using a suitable
insulated wire connection device as
shown in Diagram B.

9.

Recheck all connections. Install the
Lanyard with the Fork Clip seated over the
Plunger.

10. Replace engine cover.
11. Reconnect battery.
12. Start engine. If engine does not start:

Disconnect battery, remove engine cover,
recheck all electrical connections, replace
cover and restart engine..

13. Remove Lanyard. Engine should stop

immediately.

ALL WIRING. CONNECTIONS AND TERMINA-
TIONS should be done in accordance with ABYC
Spec. E-9-90.
Use 16 AWG Purple stranded insulated marine
quality wire for I/0 or Inboard applications. (Type
HDT, THW, UL 1426 or equivalent.)
Use 16 AWG Black stranded insulated marine
quality wire for all outboard applications. (Type
HDT, THW, UL 1426 or equivalent.)

055001-695  Rev. C 10/03  © 2003 Teleflex, Inc.

6980 Professional Parkway East

Sarasota, FL 34240

(941) 907-1000

FAX (941) 907-1020

Operating Instructions
1.

Before each motor start. check that the
Lanyard Fork Clip is properly seated over the
switch and rotates freely. Inspect the Lanyard.
If it is cut. worn or frayed. it must be replaced.

2. The Lanyard Snap Hook should be securely

attached to the operatorís body. Do not attach
the Hook to a belt loop or button hole as these
lack the strength to assure proper Switch
operation.

3. Start the engine.
4. Test the Switch by pulling the Lanyard Fork

Clip free from the Switch.