Telus Modem IR1200 Benutzerhandbuch
TELUS Mobility™
22
8.
Click Close to close the Control Panel.
9.
Continue with the steps to Create a Dial-Up Networking Connection.
Create a Dial-up Networking Connection
1.
With the My Computer window open, double-click the Dial-Up Networking icon.
2.
The Dial-Up Networking window opens. Double-click Make New Connection.
3.
The Make New Connection window opens. Enter a name for the connection, such as “iR1200 Modem”. Under Select a
device, use the drop-down box to locate and select Standard 19200 bps Modems. Click Next.
device, use the drop-down box to locate and select Standard 19200 bps Modems. Click Next.
4.
The Make New Connection window changes and now displays fields for entering the phone number. Delete any
information contained in the Area Code box.
information contained in the Area Code box.
•
For Packet Data: At Telephone number: Enter s=2.
•
For Circuit Switched Data: Enter the ISP phone number.
Click Next to continue.
5.
The Setup Finish window opens, click Finish. This procedure creates the iR1200 Modem icon in the Dial-Up
Networking window.
Networking window.
6.
In the Dial-Up Networking window, right click iR1200 Modem. Click Properties.
7.
The iR1200 Modem Network window opens. Click the Server Types tab.
NOTE: For packet data, country code and area code (under the General Tab) should always be blank to allow s=2
to be the telephone number.
8.
Under Type of Dial-Up Server, select PPP.
9.
Under Allowed Network Protocols, ensure that the box next to TCP/IP is checked.
10. Remove the check marks from all other selection boxes.
11. Click the TCP/IP button.
12. The TCP/IP Settings window opens. Ensure that the following are checked:
•
Server assigned IP address
•
Server assigned name server addresses
•
Use IP header compression
•
Use default gateway on remote network
All other boxes should remain unchecked. Click OK.
13. Click OK to complete the set up.
Modem Configuration – Windows NT
Install the Modem
1.
Go to Startà Settingsà Control Panel and click on the Modems icon.
2.
The Modems Properties window opens. Under the General tab click Add.
3.
The Install New Modem window opens. Select Other then Next.
4.
The Install New Modem/Hardware Installation window opens. Check the Don't run the Hardware Installation
Wizard box. Click the Next button.
Wizard box. Click the Next button.
NOTE: If this option is not present, proceed to the next instruction.