Telus Modem IR1200 Benutzerhandbuch
iR1200 Modem
23
5.
The Install New Modem/Modem Detection window opens. Check the Don't detect my modem; I will select it
from a list box. Click Next.
from a list box. Click Next.
6.
The Install New Modem/Modem Selection window opens. Under Manufacturer, select (Standard Modem
Types). Under Models, click Standard 19200 bps Modem. Click Next.
Types). Under Models, click Standard 19200 bps Modem. Click Next.
7.
The Port Selection window opens. Highlight the COM port that you will be using to connect to the phone. Click
Next.
Next.
8.
The Modem Installation Finish window opens. Click Finish.
9.
The Modems Properties window reappears with the newly added Standard 19200 bps modem displayed in the dialog
box. Click Close.
box. Click Close.
10. The following message appears: Dial-Up Networking needs to be configured because the list has changed. Do
you wish to reconfigure? Click Yes.
11. The Remote Access Setup window opens. Click Add.
NOTE: In Windows NT, only one modem can be installed per COM port. If you are attempting to install the
Standard 19200 bps modem on a COM port to which another modem is directed, you must choose an
alternate COM port or remove the other modem before proceeding. Otherwise a conflict will occur and
Windows NT will not recognize the Standard 19200 bps modem.
alternate COM port or remove the other modem before proceeding. Otherwise a conflict will occur and
Windows NT will not recognize the Standard 19200 bps modem.
12. The Add RAS Device window opens. Make sure the proper COM port for your modem connection is selected. Click
OK.
13. The Remote Access Setup window now shows the added COM port. Click Continue. The system automatically
configures the appropriate settings.
14. Continue with the steps to Configure the Modem Driver.
Configure the Modem Driver
1.
From the Modems Properties window, select the Standard 19200 bps Modem. Click Properties.
2.
The Standard 19200 bps Modems Properties window opens. On the General tab, confirm the Maximum Speed is
19200 bps.
19200 bps.
3.
Click the Connection tab and verify the following settings:
•
Data Bits: 8
•
Parity: None
•
Stop Bits: 1
Click Advanced.
4.
The Advanced Connection Settings window opens. If they are not selected already, select the following:
•
Use Flow Control and
•
Hardware (RTS/CTS)
•
If the Duplex option is present, select Full.
5.
Click OK to close the Advanced Connection Settings window.
6.
Click OK (or Close) to close the Standard 19200 bps Modems Properties window.
7.
Click Close to close the Modem's Properties window.
8.
Click Close to close the Control Panel.
9.
Continue with the steps to Create a Dial-Up Networking Connection.
Create a Dial-up Networking Connection
1.
With the My Computer window open, double-click the Dial-Up Networking icon.