QMS 1800486-001C Benutzerhandbuch
6#
$1.%
7 %
$
/ '
(
,
Caution:
The OPC belt is extremely sensitive to bright light and direct sunlight. Always
leave it in its protective bag until you are ready to install it. Any exposure to light should
be limited to less than two minutes, or permanent damage could result. If you suspect
the belt is damaged due to exposure to light, put the belt in a dark place to recover.
Depending on the amount of exposure, recovery may take up to two hours. Recovery
time is dependent on the amount of exposure sustained. Recovery is not guaranteed.
be limited to less than two minutes, or permanent damage could result. If you suspect
the belt is damaged due to exposure to light, put the belt in a dark place to recover.
Depending on the amount of exposure, recovery may take up to two hours. Recovery
time is dependent on the amount of exposure sustained. Recovery is not guaranteed.
The OPC belt is also extremely sensitive to touch. Always handle the cartridge so you
don’t touch the surface of the belt. Any body oil left on the surface of the belt will
prevent toner from adhering to the belt which results in poor image quality. Also, keep
the cartridge away from anything that may scratch the surface of the belt. Any
scratches will show in the image produced.
don’t touch the surface of the belt. Any body oil left on the surface of the belt will
prevent toner from adhering to the belt which results in poor image quality. Also, keep
the cartridge away from anything that may scratch the surface of the belt. Any
scratches will show in the image produced.
1
Turn off and unplug the printer.
2
If you have a duplex model, open the
duplexer’s rear cover.
duplexer’s rear cover.
If not, skip to step 3.