Elmo Computer Hardware 1.1 Benutzerhandbuch

  Notes for connecting the CANopen communication cable:  

 Connect the shield to the ground of the host (PC). Usually, this connection is 

soldered internally inside the connector at the PC end. You can use the drain wire to 
facilitate connection. 

 Ensure that the shield of the cable is connected to the shield of the connector used for 

communications. The drain wire can be used to facilitate the connection. 

 Make sure to have a 120-ohm resistor termination at each of the two ends of the 

network cable. 

 The Guitar’s CAN port is non-isolated. 

Guitar Installation Guide 

Installation 

MAN-GUIIG (Ver. 1.1) 

 

3-36