Fujitronic Programmable Operation Display UG520H-x Benutzerhandbuch

15 Analog RGB Input

With this function, you can manipulate the Windows screen displayed on the POD with touch

switches, i.e. without using the mouse.

Applicable version of screen development editor

This function is adapted to 2.4.0.0 or newer versions of the screen development editor.

Applicable version of POD system program

This function is adapted to 1.200 or newer versions of POD system program (SYSTEM PROG.VER.)

Touch panel driver to be installed

PN-WIN98/95 Ver. 2.00J (Japanese version) from GUNZE.

Operating environment of the access vision driver

Computer: DOS/V personal computer

OS:

Windows98/95

Restrictions

1. DOS application software that runs on MS-DOS prompt cannot be operated with touch panel.

2. This function is compatible with PS/2 mouse but may not with the unique pointing device of

manufacturer’s own development that is installed mainly in note type personal computer.

About setting

1. Select [Touch Switch] from [Modular Jack 1] or [Modular Jack 2] in the [Modular] dialog box of

[System Setting].  (When you want to display the symbols for DOS/V personal computer on the POD,

send the coordinate output of the touch panel to the DOS/V personal computer via the MJ port that is

set in this step.)

2. The touch panel driver supplied from GUNZE needs to be installed in the DOS/V personal computer

in advance.  For how to install the driver, refer to the manual supplied with the GUNZE touch panel

driver.

Example of setting

The procedure for adding the “touch-switch emulation” function under the environment where the analog

RGB input function is used is described below.

In this example, it is supposed that the following setting is already made:

On the [RGB Adjust] screen, [Setting 1] is set to “BIOS screen” while [Setting 2], to “Windows

screen”.  (For details regarding the adjustment, see “Screen Adjustment” explained above.)

Connect between COM2 of the personal computer and MJ1 of the POD by means of UG00C-T (for

screen data transfer).

1. Change over to POD input screen (Windows screen is displayed).

2. Activate the screen development editor and open the file that is currently transferred to the POD.

3. Select [Touch Switch] from [Modular Jack 2] in the [Modular] dialog box of [System Setting].