Fluke Lawn Mower 2635A Benutzerhandbuch
Memory Card Operations
Initializing a Memory Card
3
3-7
Initializing a Memory Card
Perform the procedure in Figure 3-3 to initialize (format) a memory card. Memory cards
can also be formatted at a PC if it is equipped with a memory card reader. (Formatting at
a PC uses the format utility supplied with the memory card reader.)When the memory
card is formatted, a standard DOS file system and directory are put into the memory on
the card. To exit at any time (formatting not completed), press the
can also be formatted at a PC if it is equipped with a memory card reader. (Formatting at
a PC uses the format utility supplied with the memory card reader.)When the memory
card is formatted, a standard DOS file system and directory are put into the memory on
the card. To exit at any time (formatting not completed), press the
C key.
Note
Any scan data that may be stored in the internal memory waiting to be
written to a valid memory card (see paragraph 3-8 Changing the Memory
Card During Scanning) will be lost when formatting a memory card.
written to a valid memory card (see paragraph 3-8 Changing the Memory
Card During Scanning) will be lost when formatting a memory card.
Init
StAt
dir
dAtA
SEtUP
StAt
dir
dAtA
SEtUP
FILES
ENTER
yES
no
no
Init
ENTER
Selecting the INITIALIZATION mode. Insert the
memory card to be initialized. Press the FILES
key to access the FILES menu. Press the
up/down arrow keys until Init is displayed, then
press the ENTER key. The menu changes to
Init. If an error message appears, see Table 3-1.
memory card to be initialized. Press the FILES
key to access the FILES menu. Press the
up/down arrow keys until Init is displayed, then
press the ENTER key. The menu changes to
Init. If an error message appears, see Table 3-1.
Verifing the INIT mode. To verify the selection
of the initialization mode, press the up/down
arrow keys until yES is displayed in the Init menu,
then press the ENTER key. To exit the
procedure, select no and then press the ENTER
key. If yES is selected, the menu changes to
SUrE.
of the initialization mode, press the up/down
arrow keys until yES is displayed in the Init menu,
then press the ENTER key. To exit the
procedure, select no and then press the ENTER
key. If yES is selected, the menu changes to
SUrE.
Typical
Required
yES
no
no
SUrE
ENTER
Initializating the memory card. Press the
up/down arrow keys to select yES or no in the
SUrE menu, then press the ENTER key. "yES"
will initialize the memory card, erasing all
previous data (if any); "no" cancels the
procedure. If Err 1 CArd appears, the small
up/down arrow keys to select yES or no in the
SUrE menu, then press the ENTER key. "yES"
will initialize the memory card, erasing all
previous data (if any); "no" cancels the
procedure. If Err 1 CArd appears, the small
switch on the card may be in the write-protect
position. Reposition the switch and repeat this
procedure.
position. Reposition the switch and repeat this
procedure.
FILES
op39f.eps
Figure 3-3. Initializing a Memory Card