Star Micronics TUP452-24 Benutzerhandbuch

 

– 12 –

 

The LEDs and RESUME button are mounted on the NEPCB.

 

When no paper is inserted, insert more paper, then press this button to automatically feed the specified

length of paper (approx. 80 mm when the presenter is installed or approx. 30 mm when it is not). After

the paper is cut, the printer will go back on line.

 

The following settings can be made by pressing either the RESUME button or the sensor adjusting but-

ton at the same time that the power switch is turned on.

<RESUME button and power switch> 

<Sensor adjusting button and power switch> 

Note)

The Line and Page modes cannot be chosen with the panel buttons; these modes can only be 

chosen with commands.

LED

Function

HU

Lights up when errors occur
(For more details, refer to “6.6 Error Messages”.)

PE

ERR

Buzzer

LED

Function

One beep

HU lights up

 

↓

 

 2 

sec.

Release the RESUME button to execute a HEX dump. 
[*1]

Two beeps

PE lights up

Release the RESUME button to execute a test print. [*2]

[*1] The HEX dump mode remains valid until the power is turned off.
[*2] The printer continues the test print until the power is turned off.

Buzzer

LED

Function

One beep

HU lights up

 

↓

 

 2 

sec.

Release the sensor adjusting button to start sensor 
adjusting mode. [*3]

[*3] Do not continue pressing the sensor adjusting button for more than two seconds.