Star Micronics TUP452-24 Benutzerhandbuch

 

– 13 –

 

a) Reflecting sensor (black mark sensor)

 

●

 

Insert the paper in front of the sensor mechanism so that a black mark is not positioned in front of 

the sensor.

 

●

 

Adjust the reflecting sensor controller VR4 on the PCB until the HU LED lights up.

b) Paper-out sensor

 

●

 

Insert the paper in front of the sensor mechanism so that a black mark is not positioned in front of 

the sensor.

 

●

 

Adjust the paper-out sensor controller VR3 on the PCB until the PE LED lights up.

 

Selecting the open frame setting with memory switch B enables near-end sensors A and B. It is possi-

ble to determine the state of near-end sensors A and B by outputting the <EOT> command to the

printer. (This is only possible when a serial interface is used.) Refer to “Programmer’s Manual”.