Star Micronics TUP452-24 Benutzerhandbuch

 

– 19 –

 

Notes) If the cutter is not located at the home position when an error has occurred, it can be returned to 

the home position by removing the cause of the error and turning the power off, then on again.

The cutter can also be returned to the home position by turning off the power, inserting a 

screwdriver into the hole on the side of the cutter, then rotating the motor until the cutter is 

returned to the position which is believed to be the home position.

Item

Specification

Method

Guillotine-type full cutting

Drive method

DC motor

Installation

Attached to the mechanism with screws

Supply

Thickness of one sheet of paper: 60 to 85 

 

µ

 

m

Minimum cutting length

25.4 mm (no presenter)
80 mm (equipped with presenter)

Life (standard paper)

300,000 times
Paper debris must be removed.

Error

An error occurs if the cutter has not returned to the home position within
the specified time.