Technicolor - Thomson ITC250S Benutzerhandbuch

EN

 To switch the TV set on, press the 

button located under the front panel of the set.

The TV set takes up to 40 seconds to come on.
If the indicator on the front is red, the set is in standby mode.You can then:
- press the 

or any numeric button on the remote control,

- press the 

,

or 

buttons to switch the television on at the last channel

or AV programme you were watching,
- press the 

button to switch the television on at the last AV programme you were

watching.

When the set is on, the indicator on the front is blue.
 To put the TV set in standby mode, press the 

button on the remote control.When

the set is in standby mode,the indicator on the front is red.The TV set remains
powered up, but with low energy consumption.

 To switch off the TV set, press the on/off button under the front panel of the set.

 Volume control: use the 

buttons on the front of the TV set or press the

relevant buttons on the remote control to increase or decrease the volume.

 Sound mute: press the 

button to temporarily mute the sound. Press this button

again or the 

button to restore it.


 Headphone volume control: press the 

button on the remote control to

display the volume control bar.Then use the 

buttons to switch to the

headphone volume control bar. Use the 

buttons to adjust the volume.

In TV mode, press the yellow button (

) on the remote control to display the number

and name of the channel you are watching, the time, the type of sound, the zoom or
format, and the status of the Parental control function.

If the programme guide is available for this channel, the name of the programme currently
showing is displayed, along with its start time and duration and the name and start time of
the following programme are also displayed.

When you switch on the television or change channels, the number and name of the
channel are displayed.

 Using the numeric buttons:

- for channels 1 to 9, press the corresponding button;
- for channels 10 to 99,

- press the tens digit for a few seconds to display it on the screen, then press the

units digit. For instance, for programme 24, press and hold 2 to display 2-, then
press 4; or 

- press the 0 button to display “--”, then enter the two digits.

 Using the 

buttons: scroll through the channels. AV programmes are not

included in the cycle unless you use the buttons on the front of the TV set.

 Using the list of programmes: refer to page 11.
To access the channel or AV programme previously being watched, press the 

button

Press the 

button to display the last selected audio-visual programme and scan through

the other audio-visual programmes.

A

itc250s-en  27/08/04  18:01  Page 10