Technicolor - Thomson ITC250S Benutzerhandbuch

EN

 Whenever you enable the parental control function by defining a personal code you have

to enter your code to access the 

and 

menus, even if

there is no lock on. In the 

menu the option is replaced by

.

 To disable the parental control function, access the 

menu by

entering your personal code, select the 

option and

enter your code again.This option is then replaced by 

.

 The personal code is deleted every time you disable the parental control function.This

means you have to redefine it every time you enable this function again.

 Whenever you enter your code all the locks are disabled until the set is put in standby

again.

 If you have forgotten your PIN code you can cancel it:

When you are prompted to enter your code to access the 

menu,

press the 

and 

buttons on the front of your set at the same time for eight

seconds.This procedure is possible, even if you have locked the buttons on the front of
the TV  set.

 Picture in picture (PIP)

Press the 

button to display the 

menu. Select 

and press 

.The menu displays. Under the Display mode option, select one of the

following PIP display modes:

: PIP is disabled.

: a channel or av programme is displayed in a frame in a corner of the screen.

: the screen is divided vertically in two and the PIP is displayed on the right

side. Sound comes from the main programme, on the left.

When you enable the PIP function, the other options in the menu are displayed.

-

In 

mode, you can select the programme, the zoom and the position of the

frame on the screen. Select an option from the list each time using the 

buttons.

-

In 

mode, you can select the programmes to be displayed in both

pictures. Use the 

buttons to change programmes on the left side of the screen

and use the 

buttons to change programmes on the right side of the screen.

Use the 

button to swap pictures.

Press 

to close the menu. Select the option 

and press 

to return to the

menu.

 Use the 

button on the remote control to enable the different display modes in turn.

 In both display modes:
- Use the 

button to swap the channels around.

- Press the 

button to freeze the main picture.

- To apply the PIP function to an AV programme in RGB, you need to select 

as the

relevant AV source in the 

menu (see page 19).

 In Single mode:
- Use the 

button to change the size of the PIP picture.

 In 

mode:

- Teletext on the channel displayed on the left appears on the right side of the screen. Press

to disable this function.

Use the 

buttons to change programmes on the right side of the screen.

‹

‹ Zoom

‹

‹ Programme

itc250s-en  27/08/04  18:01  Page 17