Fujitsu Primecenter M1 BS2000 Benutzerhandbuch
39
Mounting in the front 19-inch area
5.2.1
Mounting support brackets
I
Support brackets are required only for asymmetrical PRIMECENTER M1
19-inch racks.
19-inch racks.
A support bracket is required for mounting components regardless of whether
telescopic rails or sliding rails are used.
telescopic rails or sliding rails are used.
Figure 11: Support brackets for 1 HU (left), 2 HU (middle) and 3 HU (right)
Support brackets with a load capacity of 15 kg (1 HU), of 35 kg (2 HU), of 50 kg
(3 HU) and of 200 kg (10 HU) are available. A cable clip can be mounted on
each support bracket for vertical cabling.
(3 HU) and of 200 kg (10 HU) are available. A cable clip can be mounted on
each support bracket for vertical cabling.
The support bracket is mounted at the appropriate height on the rear left
support upright and is used to fasten the left sliding or telescopic rail at the rear.
support upright and is used to fasten the left sliding or telescopic rail at the rear.
Required tools
The following tools are required to perform this task:
–
Torx screwdriver