Fujitsu Primecenter M1 BS2000 Benutzerhandbuch
41
Mounting in the rear 19-inch area
5.3
Mounting in the rear 19-inch area
You can mount additional rack components in the rear 19-inch area if:
–
the front area is not occupied with rack components
–
the rack components mounted in the front area leave enough space for
additional components to be mounted at the rear (in the rear area)
additional components to be mounted at the rear (in the rear area)
–
the rack components in the rear do not hinder the cooling air stream for the
components in the front area.
components in the front area.
I
Be aware that the temperature level in the rear is much higher than at
the front.
the front.
Figure 13: Example of how to mount a rack component in the 19-inch area at the back
Ê
Mount the rack component using the support uprights (1).
Only for asymmetrical PRIMECENTER M1 19-inch racks:
An appropriate support bracket is required for mounting rack components on the
left-hand side. If you cannot use an existing bracket, you will have to mount a
new support bracket at the appropriate position.
An appropriate support bracket is required for mounting rack components on the
left-hand side. If you cannot use an existing bracket, you will have to mount a
new support bracket at the appropriate position.
Ê
Mount a support bracket with the appropriate load capacity (2) (see
).
Ê
Use the support upright (1) for mounting rack components on the right-hand
side (frontside view).
side (frontside view).
V
CAUTION!
Please pay heed to the ventilation concept. The cooling of the built-in
rack components must be ensured.
rack components must be ensured.