Wasp Bar Code Wasp WPL606 Benutzerhandbuch

1.  Open the printer panels and the print head lift lever

2.  Rotate the Label Guide clockwise away from the Media Guide Bar

3.  Insert a new label roll into the label spindle

4.  Pull labels leading edge forward under the black media guide bar,

through the gap/black mark sensor and place the label leading edge onto

the Platen Roller

5.  Adjust the label guide by sliding it along its bar to meet the width of the

label. Then rotate the Label Guide counter-clockwise and secure it to the

Media Guide Bar

6.  Adjust the Gap Detector to overlap at least one inch of the label by moving

the yellow Gap Detector Handle located under the media and just in front

of the media guide bar

7.  Close the print head lift lever

8.  Close the lower front panel and printer cover

9.  Turn the power on

10.  Go to section 4.2 Gap / Black Mark Detector Sensor Calibration and

calibrate the labels

Media Guide

Bar

Gap / Black

Mark

Detector

Label

Guide

Platen

Roller

Label

Spindle

Gap

Detector

Handle

Label

Guide

Print Head

Lever