Wasp Bar Code Wasp WPL606 Benutzerhandbuch

1.  Place the printer on a flat, secure surface
2.  Make sure the POWER switch is off
3.  Connect the printer to the computer with the provided RS-232C,

Centronics/Parallel, or USB cable

4.  Plug the power cord into the power supply connector at the rear of the

printer, and then plug the power cord into a properly grounded power outlet

1.  Turn the power to the printer off
2.  Open the printer right side cover and front panel
3.  Raise print head lift lever and remove the old ribbon by firmly grasping the

media and pulling it off of the spindle

4.  Wasp ribbons are wound with the dull ink side out and come with the

rewind spindle connected to the ribbon. Slide the ribbon onto the ribbon

supply spindle so that when the rewind spindle is extended toward the

back of the printer the Wasp logo is facing up. Slide the ribbon about half

way onto the spindle

5.  Wrap the ribbon under the print head and out the front of the printer. The

Wasp logo will be facing down toward the platten roller. The Platen Roller

is the black rubber roller bar that advances the media

Ribbon

Supply

Spindle

Print Head

Lift Lever

Open

Print Head

Rewind

Core

Rewind

Spindle

Platen

Roller