Magma PCIe Expansion System EB2 Benutzerhandbuch

                                                                                                                             33 

on the OK button to close the new dialog. 
 

4.  The properties dialog should close and the original “Safely 

Remove Hardware” dialog should remain.   
 
Click on the Stop button of the dialog. 
 

5.  A dialog with the title “Stop a Hardware device” should appear.  

This device is used to confirm that the user wishes to stop this 
device.   
 
Click on the OK button of the new dialog. 
 

6.  After a brief period a pop up will appear telling the user that the 

device may be removed safely, and the device will be removed 
from the list of the original dialog.   
 
Press the Attention button that corresponds to the slot 
where the device is located. 
 

7.  An LED, labeled SLOT X Attention (where X corresponds to 

the slot number) will begin to flash.  The LED is located on the 
vertical backplane towards the back edge of the chassis as 
shown below: 

 

       

                       

 
Note: If, by mistake, you’ve pressed the button corresponding 
to the wrong slot, then press it again within 5 seconds and the 
hot plug request will be ignored. Otherwise continue to step 8.