Manualsbrain.com
  1. Handbücher
  2. Marken
  3. Leibherr USA
  4. Refrigerators and freezers for integrated use, door-on-door HRB 1110 HF 851
  5. Benutzerhandbuch

Leibherr USA Refrigerators and freezers for integrated use, door-on-door HRB 1110 HF 851 Benutzerhandbuch

Download
Seite von 14
q
the air flow is not restricted. Air flow must be provided for
the appliance to operate properly. The factory air vents
provide  31  square  inches  (200  cm
2
)  of  air  flow  per
appliance.  If  you  are  replacing  the  air  vents  with  an
overlay, the air flow must be the same or greater than the
factory air vents.
u
Examine the unit and packaging for shipping damage.
Contact the carrier immediately if you suspect there is
any damage.
u
Note the type (model, number), index, appliance/serial
number, date of purchase and where purchased .
u
Remove anything attached to the rear or side walls of
appliance  that  would  prevent  proper  installation  or
impede proper ventilation.
If the appliance is set up in humid areas, condensation may
build on the outside of the appliance.
u
Always ensure proper ventilation.
3 Reversing the door
Make sure you have the following tools on hand:
q
Phillips screwdriver
q
Slot screwdriver
q
• Cordless screwdriver Torx 15
• Cordless screwdriver Torx 20
• Cordless screwdriver Torx 25
Disconnect the power plug.
Open the door.
3.1 Detaching the soft stop
mechanism
Fig. 1 
CAUTION
Risk of injury if soft stop contracts!
u
Detach with care.
u
Use a screwdriver to slide the tension spring
 Fig. 1 (11)
outwards.
u
Remove the soft stop mechanism
 Fig. 1 (2)
 by pulling it
downwards.
u
Unscrew the retainer
 Fig. 1 (1)
.
u
Unscrew  the  ball  stud
  Fig.  1  (3)
  using  an  open-ended
wrench.
3.2 To remove the door
Fig. 2 
u
Remove the covers
 Fig. 2 (4)
.
u
Just loosen the fixing screws
 Fig. 2 (5)
.
u
Remove door: Push outwards, unhook and put to one
side.
3.3 Swapping bearing parts
CAUTION
Hinges are spring-loaded and can cause pinching injuries!
u
Leave hinges open.
u
Swap  the  fixing  screws
Fig.  2  (5)
  on  the  top  and
bottom  to  the  opposite
side.
The screws are self-tapping.
Use a cordless screwdriver:
u
Unscrew
  Fig.  3  (9)
  the
hinges from the door and
swap them over.
u
Close off the now unused
holes 
with 
plugs
Fig. 3 (10)
.
Fig. 3 
3.4 Installing the door again
u
Hang the appliance door on the pre-fitted fixing screws
Fig. 2 (5)
.
u
Tighten the fixing screws
 Fig. 2 (5)
.
u
Re-attach the covers
 Fig. 2 (4)
.
Reversing the door
3