Dacor DCT365BLPH Installationsanweisungen

Cabinet and Countertop Layout

•  Failure to meet or exceed the maximum and mini-

mum dimensions/clearances stated in these instruc-

tions may result in a fire hazard.

•  Follow the countertop manufacturer’s instructions 

regarding the minimum corner radius, use of heat 

reflective tape, reinforcement of corners, etc.

•  Carefully check the location where the cooktop will be 

installed. For best performance, the cooktop should be 

placed away from drafts that may be caused by doors, 

windows and heating and air conditioning outlets. 

•  This appliance is to be used in conjunction with a suit-

able vent hood.

36” (91.4 cm)

42” (106.7 cm)

Installation Specifications

•  Allow a minimum ¼” (6 mm) clearance between the 

bottom of the cooktop chassis and all combustible sur-

faces, including the upper edge of a drawer installed 

below the cooktop.

•  The gas supply piping, gas shut-off valve and the elec-

trical outlet must be located so that they do not inter-

fere with the cooktop when it is installed. If installing 

another appliance in the cabinet below, allow for the 

routing of gas and electrical service behind it.

The installation must allow for the following:
•  Access to the gas shut-off valve and regulator when 

the unit is installed. 

•  Access to the electrical outlet when the cooktop is in 

place. The 42” (106.7 cm) power cord must be able to 

reach the electrical outlet.

•  Access to the underside of the cooktop for service and 

inspection purposes.

•  Clearance inside the cabinet to allow for proper hold 

down bracket installation.

To allow access to the utilities and cooktop bottom, a fixed 

shelf should not be installed below the cooktop. See the fol-

lowing pages for countertop cutout dimensions.

¼” (6 mm)

mimimum clearance

to combustible

surfaces

 35 ¼” (89.5 cm)*

 * Allows for clearance between hold down brackets

13" max.

3

(33.0 cm)

3

 Not applicable for cabinets more than a horizontal distance of  

  

 

5 ½” (14.0 cm) from edge of cooktop. Allow 6 

7

/

8

” (17.5 cm) 

  

 

from cutout edge.

A

  18" min.

1, 3

(45.7 cm)

 1 

5

/

8

" min. 

(4.1 cm)

Combustible 

surface to rear

Combustible overhead 

cabinets

30" min.

1, 2

(76.2 cm)

See cutout dimensions

See cutout

dimensions

2

 If installing with an overhead vent hood, also check the hood 

  

 

specifications for minimum required clearances.

1

 Measured from the cooking surface (top of cooktop grate).

All tolerances +1/16” (+1.6 mm), -0 

unless otherwise noted.