Dacor DCT365BLPH Installationsanweisungen

Verify Package Contents

•  Hold down brackets (2)
•  Grates (3)
•  Burner sets (5)
•  Gas pressure regulator with ¾” to ½” reducer
•  Stainless steel cleaner

Installing the Cooktop

•  Verify that the power supply meets the specifications 

on page 4 before proceeding.

•  To prevent damage to the gas pressure regulator, 

install it only after the cooktop is mounted in its per-

manent position.

•  Do not over-tighten the hold down bolts. Over tight-

ening the hold down bolts may result in improper 

operation of the dual gas burners.

•  Do not use a hardening compound or caulk to perma-

nently seal the cooktop into place. The cooktop must 

be readily removable if service is required. Removal 

of sealant to service the unit will be performed at the 

customer’s expense.

1.  Lower the cooktop into the cutout. Slide it forward as 

far as possible and center it side to side.  

2.  Secure the cooktop to the countertop using the two (2) 

provided hold-down brackets as shown.

Installation Instructions

Connecting the Gas Line

•  Verify that the gas supply meets specifications before 

connection. See page 4.

•  Do not install the cooktop without also installing the 

included gas regulator. Do not use the cooktop with-

out the regulator installed.

•  Ensure that the arrow on the regulator points in the 

direction of the gas flow, towards the cooktop.

•  Do not apply excessive pressure when tightening gas 

connections and fittings.

•  Do not use Teflon tape or plumber’s putty on flexible 

gas line connections.

•  Test the gas lines for leaks as instructed before use. 

Do not use a flame to check for leaks. 

•  The maximum gas supply pressure to the regulator 

must never exceed ½ pounds per square inch (p.s.i.) 

or 3.5 kPa.

•  The cooktop and shut-off valve must be disconnected 

from the gas supply piping system during any pres-

sure testing exceeding ½ p.s.i. (3.5 kPa).

•  The cooktop must be isolated from the gas supply 

piping system by closing the shut-off valve to the 

cooktop during any gas supply piping system pres-

sure testing equal to or less than ½ p.s.i. (3.5 kPa).

•  For LP gas installations, the LP gas tank must have 

its own high-pressure regulator in addition to the 

pressure regulator supplied with the cooktop.

1.  Attach the gas pressure regulator (included with the 

cooktop) to the cooktop pipe nipple inlet. For tight 

installations, the regulator may be installed upstream 

from the pipe nipple, anywhere between the shut-off 

valve and the cooktop. For best performance, minimize 

gas pressure loss by attaching the regulator as close 

as possible to the cooktop gas inlet.

2.  Complete connection of the gas supply to the cooktop 

by installing a minimum ½” flexible gas line (not includ-

ed) between the pressure regulator and the shut-off 

valve.

3.  Check for gas leaks:

◊  Turn all cooktop control valves to the 

OFF position.

◊  Turn on the gas supply valve and check all lines 

and connections for leaks using a soap and water 

solution or a gas leak detector.

◊  Turn the gas supply off.

Power cord

Gas inlet

Hold down 

bracket mounting holes 

(both sides)