Maytag MHN30PDCWW Installationsanweisungen

IMPORTANT: Position the washer so that the rear of the washer 

is within approximately 3 ft. (900 mm) of its final location.
There are 4 shipping bolts in the rear panel of the washer that 

support the suspension system during transportation. These  

bolts also retain the power cord inside the washer until the bolts 

are removed.

 1.  Keep the washer in the upright position while removing the 

shipping bolts.

 

■

A 120 volt, 60 Hz., AC only, 15- or 20-amp, fused electrical 

supply is required. A time-delay fuse or circuit breaker is 

recommended. It is recommended that a separate circuit 

serving only this washer be provided.

 

■

This washer is equipped with a power supply cord having  

a 3 prong grounding plug.

 

■

To minimize possible shock hazard, the cord must be 

plugged into a mating, 3 prong, grounding-type outlet, 

grounded in accordance with local codes and ordinances. 

If a mating outlet is not available, it is the personal 

responsibility and obligation of the customer to have the 

properly grounded outlet installed by a qualified electrician.

 

■

If codes permit and a separate ground wire is used, it is 

recommended that a qualified electrician determine that the 

ground path is adequate.

 

■

Do not ground to a gas pipe.

 

■

Check with a qualified electrician if you are not sure the 

washer is properly grounded. 

 

■

Do not have a fuse in the neutral or ground circuit.