Dacor DYRP48DSNGH Installationsanweisungen

Installation Instructions

Refer to the range rating label (see page II) for power 

requirements.
There are four possible ways to wire the range:
• 

4 wire conduit

• 

3 wire conduit (where local codes permit)

• 

4 wire appliance cord (where local codes permit)

• 

3 wire appliance cord (where local codes permit)

The sections below and on the following pages give directions for 

connecting each type of wiring harness.

Do not connect the green appliance wire to the neutral (white) 

supply wire unless local building codes permit.

Connecting Conduit to the Range

NOTE: For connection of an appliance cord, see page 14.
1.  Remove the range electrical access cover from the back of 

the range.

2.  If using a 4 wire 

connection, loosen the 

grounding screw and 

remove the neutral to 

ground jumper link.

3.  Remove the nut from the 

conduit strain relief (not 

included).

4.  Slide the wires and the 

end of the strain relief into 

the hole on the bottom of 

the range electrical box.

5.  Before connecting the wires, slide the strain relief nut over 

the wires and thread it onto the conduit strain relief inside the 

box. Tighten into place.

6.  Connect the white wire to the neutral terminal in the box.
7.  Connect the black wire to the L1 power supply terminal.
8.  Connect the red wire to the L2 power supply terminal.
9.  If using a 4 wire connection, connect the green wire to the 

grounding screw inside the box.

10.  Replace the range electrical access cover.

Bare wire 

connections

Loop and  

spade terminal 

connections

L1 terminal

L1 terminal

L2 terminal

L2 terminal

Black wire

Red wire

White wire

Green wire

Red wire

White wire

Black wire

Conduit strain 

relief nut

Conduit strain 

relief nut

Neutral terminal

Neutral terminal

Jumper link

Jumper removed

Grounding screw