Dacor DYRP48DSNGH Installationsanweisungen

Electrical Connection (cont.)

Connecting the Conduit to the House 

Electrical Junction Box

Do not connect the green appliance wire to the neutral (white) 

supply wire unless local building codes permit.

◊  The power supply must be properly polarized. Reverse 

polarity will result in continuous sparking of the burner 

ignitors, even after flame ignition.

◊  If there is any doubt as to whether the power supply is 

properly polarized or grounded, have it checked by a 

licensed electrician.

1.  With the range positioned directly in front of the cabinet 

cutout, feed the appliance wires into the junction box. 

Depending upon local codes, utilize one of the three (3) 

methods shown to connect the appliance to the junction box.

2.  After connecting the conduit to the range (see page 11) 

connect the white wire from the appliance to the neutral 

(white) supply wire in the junction box.

3.  Connect the black wire from the appliance to the black (L1) 

power supply wire in the junction box.

4.  Connect the red wire from the appliance to the red (L2) power 

supply wire in the junction box.

5.  If using a 4 wire connection, connect the green wire to a 

grounded supply wire in the junction box or to a grounded 

cold water pipe. If connecting to a grounded cold water pipe:
◊  Use a separate copper grounding wire (No. 10 minimum) 

to connect to the cold water pipe by means of a clamp 

and an external grounding connector screw.

◊  If there are any materials that isolate the cold water pipe 

from ground, jumper it with a No. 4 copper wire, clamped 

on both ends.

6.  Replace the cover on the junction box.

Installation Instructions

Connection to 

power supply

Wire nut 

3 places

Junction box

Connection to appliance 

RED
RED

GREEN

WHITE
WHITE

BLACK
BLACK

GREEN

Connection to 

power supply

Wire nut 

4 places

Junction box

Connection to appliance