Dacor DYRP48DSNGH Installationsanweisungen

Planning the Installation

B

A

C

D

Shown with electrical 

access cover removed

E - Electrical wiring 

access hole in bottom

Back of range

Gas 

Inlet

1

1

2

DYRP36D[-C-]S

6 3/4”  

(17.1 cm)

27”  

(68.6 cm)

12”  

(30.5 cm)

6 3/4” 

(17.1 cm)

7/8” dia. 

(2.2 cm)

DYRP48D[-C-]S

4 1/4”  

(10.8 cm)

27”  

(68.6 cm)

9”  

(22.9 cm)

6 3/4” 

(17.1 cm)

7/8” dia. 

(2.2 cm)

1

 Measurement with appliance legs adjusted to lowest height. 

2

 The hole size for the electrical wiring may be increased to 1 1/8” (2.9 cm) by 

removing the conduit bracket in the bottom of the range electrical box. Model 

numbers ending with -C come from the factory pre-wired with an appliance cord and 

no adapter (E = 1 1/8”). 

Gas Supply Requirements

• 

The installation of this appliance must conform with local 

codes or, in the absence of local codes, with the National 

Fuel Gas Code, ANSI Z223.1/NFPA 54.

• 

Be certain that the appliance being installed is correct for 

the gas service provided (natural gas or LP gas). Also, if 

operating the range at an altitude above 4000 ft. (1219 m) 

make sure it is equipped for high altitude operation. Refer 

to the range rating label and the table on the inside cover to 

determine the correct model.

• 

See the table to the right for gas supply pressure 

requirements.

• 

The regulator inlet accommodates a 3/4” gas line. The range 

ships with a 1/2” to 3/4” adapter connected to the regulator.

(All units)

Natural Gas

5” Water Column

6” Water Column

Liquid Propane (LP) 10” Water Column

11” Water Column

* The gas supply pressure for testing the regulator setting shall 

be at least 1 inch water column (249 Pa) above the specified 

manifold pressure.
** Maximum gas supply pressure for all models: 1/2 psi.
The ratings above are for reference only. Refer to the range rating 

label for exact specifications (see page II for location).