Frigidaire FFGS3025PS Installationsanweisungen

  The counter-top around the cut-out should be flat and leveled (see 

hatched area on illustration 1).

  Before installing the unit, measure the heights of the two (2) cabinet 

sides (H1-4), front and back (see illustration 1) from the floor to the 

top of the counter.

H1

H2

H3

H4

Illustration 1

Shave Raised Edge 

to Clear Space for 

a 31½" (80 cm) 

Wide Cooktop.

1 ½" Max.

(3,8 cm Max.)

device: Remove and discard the two rear leveling legs, they are only in place to 

solidify the unit during the transport. 

  Slide the unit into the cabinet. Make sure the center of the unit is aligned with the center 

Illustration 2

To 

successfully 

install the 

range, the 

initial level 

height from 

floor to 

underside 

of cooktop 

frame should 

be at least 

1/16" (0,16 

cm) taller than 

cabinet sides 

as measured 

in step 2.

of the cabinet cut-out.

  Remove  the  protective  channels  on  each  side  of  cooktop  (if 

equipped).

  The metal flange under each side of the cooktop 

MUST be placed 

over the cabinet countertop for proper unit support. The cooktop 

should 

NOT directly touch the countertop (see illustration 2) or 

Metal 

Flange

  Level the range using the 

leveling legs or leveling device 

so that the height from the 

floor to the underside of the 

cooktop frame is greater than 

the tallest cabinet measurement 

by at least 1/16" (0,16 cm) (see 

illustration 2).

  Model equipped with leveling 

  After the installation, 

MAKE SURE 

that the unit is 

supported by the 

leveling legs NOT 

by the cooktop.

else it could cause damage to the cooktop 

voiding the warranty. Level the unit if 

needed.