Dacor RNRP36G Installationsanweisungen

2.  To install the bracket, place it against the wall in the mounting 

location. Using a drill with a 1/8” diameter drill bit, drill four 

(4) 1 5/8” deep pilot holes perpendicular to the screw seating 

surfaces shown below. Attach the bracket to the wall as 

shown with the four (4) included #12 x 1 3/4 screws.

Installing the Anti-Tip Bracket on the Wall

1.  Determine the suitability of wall mounting the anti-tip bracket. 

To use the wall mount option, the range front panel (excluding 

the bull nose) must not be more than 27” (68.6 cm) from the 

wall and the bracket screws must be able to thread into the 

base plate inside the wall behind. The notches on the sides 

of the bracket indicated the minimum required height of the 

base plate inside the wall and that any floor covering is not 

too thick for proper screw thread engagement.

◊  Determine the location of the range center line and front 

panel when the range is in its final position based on the 

product dimensions on page 5 and the actual cabinet/

cutout dimensions used for the installation.

◊  Determine and mark the required position of the anti-tip 

bracket, based on the diagram above. Push the bracket 

up against the wall in the mounting location.

◊  Using a pencil, make a dot next to the notches on both 

sides of the bracket. Determine if the base plate is as 

high at the notches by drilling test holes into the wall at 

both dots with a 1/16” drill bit. Drill just deep enough to 

see if the bit contacts the base plate. If the bit contacts 

the base plate the location will support wall installation of 

the anti-tip bracket. If you do not contact the base plate, 

the wall mounting method may not be used and the floor 

mounting method must be suitable, or the wall must be 

modified so that the base plate is above the notches.

Installation Instructions

CL

CL

Bracket

center line

Range front

panel*

#12 x 1 3/4” 

screw, 4 places

This hole lines up with

bracket center line

Back wall

Range

center line

Wall

Anti-tip

bracket

Base 

plate

Drywall

Notch

C

11 7/8” (30.2 cm)

2 1/2” (6.4 cm)

* Excludes bull nose (see page 4)