Dacor RNRP36G Installationsanweisungen

10 7/8” (27.6 cm)

1 1/2” (3.8 cm)

22 1/2” (57.2 cm)

22 1/2” (57.2 cm)

* Excludes bull nose (see page 4)

Concrete or wood sub-

floor, no floor covering over 

top

#8 x 1 *

Concrete or wood sub-

floor, floor covering up to 

1/4” thick

#8 x 1 *

Concrete or wood sub-

floor, floor covering over 

1/4” and up to 1/2” thick

#8 x 1 1/4 *

Wood sub-floor, floor 

covering over 1/2” and up 

to 1 3/16” thick

#12 x 1 3/4 *

Concrete under floor 

covering over 1/2” thick

Must be purchased separately **

Wood sub-floor, floor 

covering over 1 3/16” thick

Must be purchased separately **

* Included with range
** Determine required depth based on information in step 3 and 

purchase from local hardware store.

Installing the Anti-Tip Bracket on the Floor 

(cont.)

1.  Determine the location of the range center line and front 

panel for the range’s final position based on the Product 

Dimensions on page 5 and the actual cabinet/cutout 

dimensions used for the installation.

2.  Determine the required position of the anti-tip bracket, based 

on the diagram below. Mark the four (4) mounting hole 

locations on the floor with a pencil.

3.  Determine the screw size required. The minimum full thread 

depth (portion of screw threaded into wood/slab) for wood is 

3/8” (1 cm) and 5/8” (1.6 cm) for concrete. See 

TABLE to select the correct screw size.

• 

Drill four (4) 3/8” diameter countersink holes through any 

existing floor covering down to the concrete slab below.

• 

Drill the 4 holes for the anchors 1 1/4” (3.2 cm) deep into the 

concrete slab using a 3/16” masonry bit. This hole length is 

longer than the anchor, but is required for proper installation. 

Clear the holes of dust and any other material. Tap each 

anchor into the hole until the anchor top is flush with the top 

of the concrete slab. Position the anti-tip bracket holes over 

the anchor holes. Insert the screws through the 4 holes in 

the base of the bracket and thread them into the anchors. Be 

sure the screw threads fully engage the anchor body. Tighten 

the screws into place.

• 

If there is ceramic, asphalt or other hard floor covering over 

the wood below, drill (4) countersink holes to allow access to 

the wood below for drilling pilot holes.

• 

Drill four (4) pilot holes into the wood floor using a drill bit 

(1/16” dia. for #8 screws, 1/8” dia. for #12 screws). Position 

the anti-tip bracket holes over the holes in the floor. Insert the 

screws into the wood and tighten into place.

Installation Instructions

CL

B

Anchor, 4 places:

use for concrete

floor only

Range 

center line

Range front 

panel*

#8 x 1”

#8 x 1 1/4” or

#12 x 1 3/4

screw,

4 places

(see text)

A