Maytag MHN30PRCWW Installationsanweisungen

■

A 120 volt, 60 Hz., AC only, 15- or 20-amp, fused electrical 
supply is required. A time-delay fuse or circuit breaker is 
recommended. It is recommended that a separate circuit 
serving only this washer be provided. 

■

This washer is equipped with a power supply cord having a 
3 prong grounding plug.

■

To minimize possible shock hazard, the cord must be 
plugged into a mating, 3 prong, grounding-type outlet, 
grounded in accordance with local codes and ordinances. If a 
mating outlet is not available, it is the personal responsibility 
and obligation of the customer to have the properly grounded 
outlet installed by a qualified electrician.

■

If codes permit and a separate ground wire is used, it is 
recommended that a qualified electrician determine that the 
ground path is adequate.

■

Do not ground to a gas pipe.

■

Check with a qualified electrician if you are not sure the 
washer is properly grounded. 

■

Do not have a fuse in the neutral or ground circuit.

IMPORTANT: Position the washer so that the rear of the washer 
is within approximately 3 ft (900 mm) of its final location.

There are 4 shipping bolts in the rear panel of the washer that 
support the suspension system during transportation. These 
bolts also retain the power cord inside the washer until the bolts 
are removed. 

1. Keep the washer in the upright position while removing the 

shipping bolts.