Maytag MHN30PRCWW Installationsanweisungen

2. Attach the cold water hose to the washer’s cold (C) water 

faucet. Screw on coupling by hand until it is seated on the 
washer.

3. Using pliers, tighten the couplings with an additional 

two-thirds turn.

NOTE: Do not overtighten. Damage to the coupling can 
result.

4. Turn on the water faucets completely and check for leaks and 

at washer connection.

NOTE: Replace inlet hoses after 5 years of use to reduce the 
risk of hose failure. Record hose installation or replacement 
dates on the hoses for future reference.

Periodically inspect and replace hoses if bulges, kinks, cuts, 
wear, or leaks are found.

1. Use locking pliers, squeeze hose clamp tabs together and insert 

over the end of drain hose. 

2. Slide drain hose onto washer connection.    

3. Once drain hose is in place, release pliers.  

Washer drain system can be installed using a floor drain, wall 
standpipe, floor standpipe, or laundry tub.

Laundry tub drain or standpipe drain
Connect the drain hose form to the corrugated drain hose. 

■

Use the drain hose form, and do not force excess drain hose 
into standpipe. Hose should be secure, but loose enough to 
provide a gap for air.

■

Do not lay excess hose on the bottom of the laundry tub.

You may need additional parts. See Floor drain under “Tools 
and Parts.”

Drain hose must be secured to stop the hose from moving when 
water is pumped out. If the drain hose moves, water may end up 
on the floor.
1. Drape the power cord over the washer top.
2. Move the washer to its final location.
3. Place the drain hose in the laundry tub or standpipe as shown. 

See illustrations A and B.