Summit CL63FDOS Benutzeranleitung

Before installation of your appliance 

  The placement of the appliance must meet 

the requirements in the section Operating 
conditions on page 9 and must include a 
stable floor with a load-bearing capacity 
corresponding to the weight of the 
appliance. 

  Level the appliance using the adjustable 

feet. Ensure there is a gap between the 
bottom edge of the appliance and the 
ground, so that there is sufficient circulation 
of air. This will ensure the optimal 
performance of the cooling system. 

  Check whether any coolant circulation   

pipes have been damaged during 
installation.   

 
  Use the appliance only for the purposes for 

which it has been designed. 

  The appliance must be located on a rigid 

and even surface. In this way you will 
ensure free circulation of the coolant and 
effective operation of your appliance. 

  If possible, place the appliance in a cool, 

well-ventilated and dry area. 

 

Do not locate the appliance in direct 
sunlight or in a room with a high ambient 
temperature, or in the vicinity of any 
sources of direct heat, such as a radiator or 
oven. This would cause the compressor to 
work harder, resulting in a substantially 
higher power consumption level.

 

FOR YOUR SAFETY 
While performing installations described in this section, gloves, safety glasses or 
goggles should be worn.

 

NOTE: For free standing installation, allow at least 4” of clearance at the back, sides 

and  top  of  the  unit  to  permit  the  proper  air  circulation  to  cool  the  compressor  and 
condenser. Even for built-in installation, you should provide the following clearances 

to ensure the best operation and proper ventilation: 3/16” on both sides, 2” at the 

rear and 1/16” at the top. Take care that the air vent at the front of the appliance is 
never covered or blocked in any way.