Summit BIM44G Benutzerhandbuch

grains/ liter), you may need to clean the system as often as once every 6 months.

1. Make sure that all the ice is off the evaporator. If ice is being formed, wait until the

cycle is completed, then press the machine’s ON/OFF switch on the control panel.

2. Remove all ice from the storage bin.

3. Keep the ice maker connected to the water supply. Pour 8 oz. of Nickel-Safe Ice

Maker Cleaner Solution into the water trough. Then press the ON/OFF switch and the

CLEAN button, initiating the wash cycle. The machine will run in the Automatic

Clean Mode.

4. Allow 30 minutes for proper cleaning. After cleaning, press the ON/OFF switch again.

Use a drain hose on the front of the water trough to drain off the waste water to a

convenient container.

NOTE: Don’t drain off the waste water to the inside of the cabinet.

5. Repeat steps 3 and 4 (without Ice Maker Cleaning Solution) three times to rinse the ice

making system thoroughly.

• NOTE: Ice Maker Cleaner Solution in the water bin during the rinse is not

needed.

6. Prepare a sanitizing solution made of 1 ounce of household bleach and 2 gallons of hot

water (95º to 115ºF). Wipe the entire bin inside and outside, covering the entire surface

of the walls.

7. Fill a spray bottle with the sanitizing solution and spray all corners and edges, making

sure to cover all surfaces with the solution.

8. Allow the solution to be in contact for at least 3 minutes, then dry.

9. Repeat step 5 to rinse the ice making system one more time.

10. Press the ON/OFF button again. The machine will return to the regular ice making

mode. Discard the first batch of ice.

The ice machine cleaner contains acids.
DO NOT use or mix with any other solvent-based cleaner products.
Use rubber gloves to protect hands. Carefully read the material
safety instructions on the container of the ice machine cleaner.
Discard the first batch of ice produced after cleaning.