Amana AGR5330BAB Installationsanweisungen

Cabinet opening dimensions shown are for 25" (64.0 cm) 
countertop depth, 24" (61.0 cm) base cabinet depth and 36" 
(91.4 cm) countertop height.

If the cabinet depth is greater than 24" (61.0 cm), oven frame 
must extend beyond cabinet fronts by ½" (1.3 cm) minimum.

IMPORTANT: If installing a range hood or microwave hood 
combination above the range, follow the range hood or 
microwave hood combination installation instructions for 
dimensional clearances above the cooktop surface.

*NOTE: 24" (61.0 cm) minimum when bottom of wood or metal 

cabinet is covered by not less than 

¹⁄₄" (0.64 cm) flame retardant 

millboard covered with not less than No. 28 MSG sheet steel, 
0.015" (0.4 mm) stainless steel, 0.024" (0.6 mm) aluminum or 
0.020" (0.5 mm) copper.

30" (76.2 cm) minimum clearance between the top of the 
cooking platform and the bottom of an uncovered wood or metal 
cabinet.

IMPORTANT: The range must be electrically grounded in 
accordance with local codes and ordinances, or in the absence 
of local codes, with the National Electrical Code, ANSI/NFPA 70, 
latest edition.

If codes permit and a separate ground wire is used, it is 
recommended that a qualified electrical installer determine that 
the ground path is adequate.

A copy of the above code standards can be obtained from:

 National Fire Protection Association

1 Batterymarch Park

Quincy, MA 02169-7471

CSA International

8501 East Pleasant Valley Road

Cleveland, OH 44131-5575

■

A 120 volt, 60 Hz., AC only, 15-amp fused, electrical circuit is 
required. A time-delay fuse or circuit breaker is also 
recommended. It is recommended that a separate circuit 
serving only this range be provided.

■

This range is equipped with a power supply cord having a 
3 prong ground plug. To minimize possible shock hazard the 
cord must be plugged into a grounded 3 prong outlet.

■

Electronic ignition systems operate within wide voltage limits, 
but proper grounding and polarity are necessary. Check that 
the outlet provides 120-volt power and is correctly grounded.

This range is equipped with an electronic ignition system that 
will not operate if plugged into an outlet that is not properly 
polarized. 

■

Performance of this range will not be affected if operated on a 
GFCI-protected electrical outlet. However, occasional 
nuisance tripping of the GFCI breaker is possible due to the 
normal operating nature of electronic gas ranges.

■

The wiring diagram is located on the back of the range in a 
clear plastic bag.

NOTE: The metal chassis of the range must be grounded in 
order for the control panel to work. If the metal chassis of the 
range is not grounded, no keypads will operate. Check with a 
qualified electrician if you are in doubt as to whether the 
metal chassis of the range is grounded.

¹⁄₈

A

B

C

D

E

F

G

H

J

K

M

L

L

N

I