Whirlpool WGE555S0BB Installationsanweisungen

Attaching terminal lugs to the terminal block - 20 lbs-in. (2.3 N-m)

3. Use 

³⁄₈" nut driver to connect the bare (green) ground wire to 

the center terminal block post with one of the 10-32 hex nuts.

4. Connect line 1 (black) and line 2 (red) wires to the outer terminal 

block posts with 10-32 hex nuts.

5. Securely tighten hex nuts.
6. Replace terminal block access cover.

1. Place the outside of your foot against the bottom front of the 

oven door to keep the range from moving, and grasp the lower 
right or left side of the control panel as shown.
NOTE: If your countertop is mounted with a backsplash, it may 
be necessary to grasp the range higher than is shown in the 
illustration.

2. Slowly attempt to tilt the range forward. 

If you encounter immediate resistance, the range foot is 
engaged in the anti-tip bracket.

3. If the rear of the range lifts more than ½" (1.3 cm) off the floor 

without resistance, stop tilting the range and lower it gently 
back to the floor. The range foot is not engaged in the anti-tip 
bracket.

IMPORTANT: If there is a snapping or popping sound when lifting 
the range, the range may not be fully engaged in the bracket. 
Check to see if there are obstructions keeping the range from 
sliding to the wall or keeping the range foot from sliding into the 
bracket. Verify that the bracket is held securely in place by the 
mounting screws.
4. Slide the range forward, and verify that the anti-tip bracket is 

securely attached to the floor or wall.

5. Slide range back so the rear range foot is inserted into the slot 

of the anti-tip bracket.

IMPORTANT: If the back of the range is more than 2" (5.1 cm) from 
the mounting wall, the rear range foot may not engage the bracket. 
Slide the range forward and determine if there is an obstruction 
between the range and the mounting wall. If you need assistance 
or service, refer to the “Assistance or Service” section of the Use 
and Care Guide, or the cover or “Warranty” section of the User 
Instructions, for contact information.
6. Repeat steps 1 and 2 to ensure that the range foot is engaged 

in the anti-tip bracket.
If the rear of the range lifts more than ½" (1.3 cm) off the floor 
without resistance, the anti-tip bracket may not be installed 
correctly. Do not operate the range without anti-tip bracket 
installed and engaged. Please reference the “Assistance or 
Service” section of the Use and Care Guide, or the cover or 
“Warranty” section of the User Instructions, to contact service.

1. Place a rack in oven. 
2. Place level on rack and check levelness of range, first side to 

side; then front to back.

3. If range is not level, pull range forward until rear leveling leg is 

removed from the anti-tip bracket. 

4. Use wrench to adjust leveling legs up or down until range is 

level. Push range back into position.

5. Check that rear leveling leg is engaged in anti-tip bracket.
NOTE: Range must be level for satisfactory baking performance.

8 gauge copper

25 lbs-in. (2.8 N-m)

6 gauge aluminum

35 lbs-in. (4.0 N-m)

B

F

A

E

D

C