Dacor DR30GIFSLP Installationsanweisungen

Gas Connection

•  Make sure the gas is turned off at the gas supply 

valve before connecting the gas line.

•  Verify that the gas supply meets specifications before 

connection. See page 5.

•  Do not apply excessive pressure when tightening gas 

connections and fittings.

•  Do not use Teflon tape or plumber’s putty on flexible 

gas line connections.

•  Test the gas lines for leaks as instructed before use. 

If a leak is detected, open all doors and windows and 

allow the gas to dissipate before fixing the leak and 

testing the unit.

•  Do not use a flame to check for leaks.
•  The maximum gas supply pressure to the regulator 

must never exceed 1/2 pounds per square inch (psi) 

or 3.5 kPa.

•  The range and its individual shutoff valve must be 

disconnected from the gas supply piping system 

during any pressure testing of that system at test 

pressures in excess of 1/2 psi (3.5 kPa).

•  The range must be isolated from the gas supply 

piping system by closing its individual manual shutoff 

valve during any pressure testing of the gas supply 

piping system at test pressures equal to or less than 

1/2 psi (3.5 kPa).

•  For LP gas installations, the LP gas tank must have 

its own high-pressure regulator in addition to the 

pressure regulator installed on the range.

IMPORTANT: The installed gas pressure regulator is pre-

set at the factory for the type of gas intended for use with 

the appliance. Verify that the appliance is compatible with 

the type of gas available by checking the product data label 

attached to the appliance. Ranges intended for use with 

LP gases will have “LP” as a part of the model number. 

Consult your dealer if the range is not compatible with your 

gas supply.
1.  Make sure the gas supply valve is in the off position 

and the range power cord is disconnected.

2.  Connect a flexible gas supply line to the gas shut-off 

valve previously installed on the stub out. The gas 

line needs to be long enough to allow the range to be 

pulled out for service.

3.  Connect the gas line to the regulator on the back of the 

range.

4.  Turn all cooktop control valves to the 

“OFF” position.

5.  Turn on the gas supply valve and check 

all lines and connections for leaks using a 

soap and water solution or an electronic 

gas leak detector.

6.  Turn the gas supply off.

1/2” male NPT 

connection*

Installation Instructions

* 3/4” male NPT connection may be used 

if the adapter on the regulator is removed.